So far we've seen how iproute works, and netfilter was mentioned a few times. This would be a good time to browse through Rusty's Remarkably Unreliable Guides. Netfilter itself can be found here.
Netfilter allows us to filter packets, or mangle their headers. One special feature is that we can mark a packet with a number. This is done with the --set-mark facility.
As an example, this command marks all packets destined for port 25, outgoing mail:
# iptables -A PREROUTING -i eth0 -t mangle -p tcp --dport 25 \ -j MARK --set-mark 1
Let's say that we have multiple connections, one that is fast (and expensive, per megabyte) and one that is slower, but flat fee. We would most certainly like outgoing mail to go via the cheap route.
We've already marked the packets with a '1', we now instruct the routing policy database to act on this:
# echo 201 mail.out >> /etc/iproute2/rt_tables # ip rule add fwmark 1 table mail.out # ip rule ls 0: from all lookup local 32764: from all fwmark 1 lookup mail.out 32766: from all lookup main 32767: from all lookup default
Now we generate the mail.out table with a route to the slow but cheap link:
# /sbin/ip route add default via 188.8.131.52 dev ppp0 table mail.out
And we are done. Should we want to make exceptions, there are lots of ways to achieve this. We can modify the netfilter statement to exclude certain hosts, or we can insert a rule with a lower priority that points to the main table for our excepted hosts.
We can also use this feature to honour TOS bits by marking packets with a different type of service with different numbers, and creating rules to act on that. This way you can even dedicate, say, an ISDN line to interactive sessions.
Needless to say, this also works fine on a host that's doing NAT ('masquerading').
IMPORTANT: We received a report that MASQ and SNAT at least collide with marking packets. Rusty Russell explains it in this posting. Turn off the reverse path filter to make it work properly.
Note: to mark packets, you need to have some options enabled in your kernel:
IP: advanced router (CONFIG_IP_ADVANCED_ROUTER) [Y/n/?] IP: policy routing (CONFIG_IP_MULTIPLE_TABLES) [Y/n/?] IP: use netfilter MARK value as routing key (CONFIG_IP_ROUTE_FWMARK) [Y/n/?]
See also the Section 15.5 in the Cookbook.